www.kontron.com » User Guide « SMARC Evaluation Carrier User Guide Document revision 1.0
User’s Guide 10 www.kontron.com » MXM3 Graphics Module Mobile PCI Express Module Electromechanical Specification, Version 3.0, Revisi
User’s Guide 11 www.kontron.com 3 Block Diagrams An overall system block diagram for the SMARC Evaluation Carrier is shown on the following pag
User’s Guide 12 www.kontron.com SMARC Carrier Connector: 314 Pin 0.5mm Pitch R/A MXM3 Style Baseboard Connector Block Diagram Color Key: Configur
User’s Guide 13 www.kontron.com J29 BENCH SUPPLY CONNECTOR IF CHARGER POWER AND / OR BATTERY POWER ARE USED, THEN BENCH SUPPLY INPUT MUST
User’s Guide 14 www.kontron.com 4 Layout Diagrams The following section shows the physical location of connectors, configuration jumpers and ot
User’s Guide 15 www.kontron.com Figure4.CarrierBottom-sideConnectors
User’s Guide 16 www.kontron.com Figure 5. Carrier Top-side LEDs
User’s Guide 17 www.kontron.com 5 Connectors – Cabled Interfaces Wired connections to the SMARC Evaluation Carrier are described in this sectio
User’s Guide 18 www.kontron.com Figure 6. Ethernet LEDs 5.3 Audio 5.3.1 J6 – Mic In Connector: CUI Inc SJ-43514-SMT, 3.5mm Audio Jack.
User’s Guide 19 www.kontron.com 5.3.3 J8 – Amplified Differential Audio Out, Left Connector: JST SM02B-SRSS-TB, 1mm pitch R/A SMD Header. Pin
User’s Guide 2 www.kontron.com » Table of Contents « 1 User Information ...
User’s Guide 20 www.kontron.com 5.3.7 J12 – Digital Microphone In Connector: JST SM03B-SRSS-TB, 1mm pitch R/A SMD Header. Pin Number Signal Not
User’s Guide 21 www.kontron.com 5.4 CAN Bus 5.4.1 J15 – CAN0 Connector: Molex 53261-0471, 1.25mm pitch R/A Header. Pin Number Signal Notes 1
User’s Guide 22 www.kontron.com 5.5.2 J18 – SER2 Connector: JST SM05B-SRSS-TB, 1mm pitch R/A SMD header. Pin Number Signal Notes 1 Serial port
User’s Guide 23 www.kontron.com 5.5.5 J21 – SER1 Connector: JST SM05B-SRSS-TB, 1mm pitch R/A SMD header. Pin Number Signal Notes 1 Serial port
User’s Guide 24 www.kontron.com 5.6.2 J23 - J25 Battery Connectors J23, J24 and J25 are slots for inserting Battery 1, Battery 2 and Battery 3 r
User’s Guide 25 www.kontron.com Connector: Molex 39-30-3045, 4.2mm pitch R/A through-hole header. Pin Number Signal Notes 1 Module Power 3.0V to
User’s Guide 26 www.kontron.com 9 LCD Data 7 BLU7 (MS bit) 11 LCD Data 8 GRN0 (LS bit) 12 LCD Data 9 GRN1 13 LCD Data 10 GRN2 14 LCD Data 11 GRN3
User’s Guide 27 www.kontron.com 5.10 Auxiliary Backlight Power 5.10.1 J33 Auxiliary Backlight Power Connector: Hirose DF11-10DP-2DSA, 2mm pitc
User’s Guide 28 www.kontron.com 6 Connectors – Standard Mezzanines, Slots and Sockets Connector part number information is given in a table in
User’s Guide 29 www.kontron.com 6.5 SD Card Slot An industry standard micro-SD Card slot is located on the back of the Eval Carrier, in position
User’s Guide 3 www.kontron.com 5.3.8 J13 – Line Level Audio ...
User’s Guide 30 www.kontron.com 7 Jumpers 7.1 Jumper J34 - LID# J34 is used to simulate LID-open and LID-closed condition, for test and devel
User’s Guide 31 www.kontron.com 7.4 Jumper J36 – LVDS Panel Color Depth – Module LVDS Jumpers J36 is used for selecting the color depth of the M
User’s Guide 32 www.kontron.com 7.7 Jumper J59 – Carrier Dual Channel LVDS Clock Edge A 24 bit dual channel LVDS implementation comprises 10 dif
User’s Guide 33 www.kontron.com 7.10 Jumpers J50 and J52 – Battery Select – Thermistor Paths Corresponding to the chosen battery combination, ba
User’s Guide 34 www.kontron.com 7.12 Jumper J27 – Step-Down Switcher Disable J27 is used to enable or disable and bypass the step-down switcher
User’s Guide 35 www.kontron.com 8 Push Button Switches 8.1 SW1 Reset Switch Switch SW1, if pressed, forces the SMARC Module RESET_IN# (Module
User’s Guide 36 www.kontron.com 9 LEDs There are 20 status LEDs on the Evaluation Carrier. Location Signal Function D11 SATA Activity Blinks o
User’s Guide 37 www.kontron.com 10 KLAS (Kontron LVDS Adapter System) Connections The Evaluation Carrier features two Kontron LVDS Adapter Syst
User’s Guide 38 www.kontron.com Figure 8. KLAS Board 43mm x 18mm Per the SMARC specification, the Module LVDS path is single-channel LVDS
User’s Guide 39 www.kontron.com Figure 9. KLAS Board 34mm x 18mm Outline
User’s Guide 4 www.kontron.com 7.6 Jumper J58 – LVDS Panel Color Depth – Carrier LVDS ...
User’s Guide 40 www.kontron.com Figure 10. KLAS Board 43mm x 18mm Outline The KLAS Module connector pin-out is as follows.
User’s Guide 41 www.kontron.com Pin Number Description Pin Number Description 1 GND 2 LCD_I2C_DAT 3 ODD_0+ 4 LCD_I2C_CK 5 ODD_0- 6 V_3V3 7 GND 8
User’s Guide 42 www.kontron.com 53 EVEN_CK- 54 V_LED_STRING_3- 55 GND 56 V_LED_STRING_4- 57 EVEN_3+ 58 V_LED_STRING_5- 59 EVEN_3- 60 V_LED_STRING
User’s Guide 43 www.kontron.com 11 I/O Mezzanine The I/O Mezzanine site accepts a 68mm x 52mm I/O Module. The I/O Module may be created by Kont
User’s Guide 44 www.kontron.com Figure 11. I/O Mezzanine Card Outline
User’s Guide 45 www.kontron.com Pin Number Description Pin Number Description 1 GND 2 GND 3 SPI0_CS0# 4 AUDIO_MCLK 5 SPI0_CS1# 6 GND 7 SPI0_CK 8
User’s Guide 46 www.kontron.com 53 GPIO3/CAM1_RST# 54 GND 55 GPIO4/HDA_RST# 56 WDT_TIME_OUT# 57 GPIO5/PWM_OUT 58 PCIE_WAKE# 59 GPIO6/TACHIN 60 SL
User’s Guide 47 www.kontron.com Notes: » Signal SER0_1_MEZ_KILL# should be tied low on the I/O Module if the I/O Module intends to drive any of
User’s Guide 48 www.kontron.com 12 MMC Mezzanine The eMMC Mezzanine is a 29.5mm x 32mm board that allows eMMC devices of various capacities and
User’s Guide 49 www.kontron.com Figure 13. eMMC Mezzanine Card Outline
User’s Guide 5 www.kontron.com 18.5 Humidity ...
User’s Guide 50 www.kontron.com The pin-out used for the eMMC Mezzanine interface is shown in the following table. Per the SMARC specification, t
User’s Guide 51 www.kontron.com 13 Camera Mezzanine The Camera Mezzanine is a 50mm x 26mm board that allows various cameras, serial and paralle
User’s Guide 52 www.kontron.com Figure 14. Camera Mezzanine Card Outline
User’s Guide 53 www.kontron.com The Camera Mezzanine pin-out to the Carrier is shown in the following table: Pin Number Description Pin Number D
User’s Guide 54 www.kontron.com 53 3.3V 54 CSI0_D1_N/PCAM_D15 55 1.8V 56 GND 57 1.8V 58 V_IO 59 NC 60 V_IO Caution! The Camera Mezzanine must e
User’s Guide 55 www.kontron.com 14 AFB Mezzanine The AFB (“Alternative Function Block”) is a set of pins in the SMARC Module spec
User’s Guide 56 www.kontron.com Figure 15. AFB Mezzanine Card Outline
User’s Guide 57 www.kontron.com The AFB Mezzanine card signal pin-out is given in the following table. The 40 signal pins are arranged by the con
User’s Guide 58 www.kontron.com 15 I2C Buses and Devices 15.1 I2C Bus Summary There are five I2C buses defined in the SMARC specification: PM
User’s Guide 59 www.kontron.com miscellaneous control 5 TI TCA9554 IO Expander U33 0x24 0x48 / 0x49 Miscellaneous control 6 Wolfson W
User’s Guide 6 www.kontron.com 1 User Information 1.1 About This Document This document provides information about products from Kontron and
User’s Guide 60 www.kontron.com Part Address (7 bit) Address (8 bit) I/O (Use as Output) Default 1 R275 Out Default 2 R275 In U35 TI TCA955
User’s Guide 61 www.kontron.com 15.4 I2C GP Bus I/O Expanders There are three I/O expanders on the I2C_GP bus, described in the tables below. “M
User’s Guide 62 www.kontron.com Device I2C Address Output Function Pulled Hi / Low U33 TI TCA9554 0x24 (7 bit) 0
User’s Guide 63 www.kontron.com 16 I2S Buses and Devices 16.1 I2S0 The SMARC I2S0 channel on the Evaluation Carrier is run through a couple o
User’s Guide 64 www.kontron.com There are no active I2S1 devices on the Evaluation Carrier (the switch is a high speed analog switch, technically
User’s Guide 65 www.kontron.com 17 Power Architecture 17.1 Block Diagram Discussion A block diagram of the supply architecture used on the Ev
User’s Guide 66 www.kontron.com IN MAX1818 OUT SHDN# POK V_1V8_LDO 1V8_LDO_POK IN TPS63020 OUT EN PG V_5V0_USB
User’s Guide 67 www.kontron.com 18 Mechanical and Environmental Parameters 18.1 Mechanical Outline Holes that may be used to mount the SMARC
User’s Guide 68 www.kontron.com 18.2 Standoffs and Screw Hardware All of the SMARC Evaluation Carrier mezzanine sites have captive, threaded sta
User’s Guide 69 www.kontron.com 19 Appendix A: Connector Mating Part Number Information Connector Reference Kontron PN Mfg MPN Qty Descrip
User’s Guide 7 www.kontron.com 1.6 Technical Support Technicians and engineers from Kontron and/or its subsidiaries are available for technical
User’s Guide 70 www.kontron.com Connector Reference Kontron PN Mfg MPN Qty Description Mating Connector PN Ref Des ,J58,J59 P
User’s Guide 71 www.kontron.com Connector Reference Kontron PN Mfg MPN Qty Description Mating Connector PN Ref Des Line-In & Line- ou
User’s Guide 72 www.kontron.com 20 Appendix B: Assembly Part Numbers Item Description PCB Number Assembly Number Orderable Part Number SMARC Ev
User’s Guide 73 www.kontron.com CAN pigtails 423-0554-00 Parallel LCD pigtails 423-0550-00 Battery Management Cable 423-0557-00
User’s Guide 74 www.kontron.com 21 Appendix C: Document Revision History Revision Date Edited by Changes 1.0 2012-09-14 DCruz Initial Public Re
User’s Guide 8 www.kontron.com 2 Introduction 2.1 General Introduction This document serves as a user manual and technical reference fo
User’s Guide 9 www.kontron.com » USB 7 port hub. » SATA MO-300 site. » Mini-PCIe sites (2) with shared SIM slot. » PCIe slot. » GbE port
Commenti su questo manuale